S2W3-Alex

 Watched FEBio webinar: Webinar: Introduction to FEBio Studio - Bing video

Notes: 





Del#5: did risk assessments 

Webinar tutorial: 








Comments

Post a Comment

Popular posts from this blog

Week #3 - Brinkley Brooks

Image
This week consisted of a lot of brainstorming, planning, and researching. I also contacted the client multiple times to figure out a shake down test we will be doing soon, and to update our deliverable 1 and 3. I also worked on making tasks and timeline for deliverable 2.  Brainstorm:  Decided on a remolded Ahmed valve with rubber material resistance (elastic) with a possible dissolving factor. This will be a combination of strategy 1 and 3.  Elastic Resistance  - most similar to Ahmed valve, but will change the resistance post fibrosis to have a better success rate 2. Magnetic Resistance  - uses a magnet to open and close a valve to vary the flow 3. Dissolvable Resistance  - Using a material that over time dissolves, so that once fibrosis occurs, the part of the valve that doesn't need to be there will be gone Client Meeting Notes:   Here are the notes I took during the client meeting. We discussed the schematic that we will be following for our shake...
Read more

Week 9 - Brinkley

Image
 This week was a lot of testing and research. I am still working on the dissolving component and figure out that data, which will make more sense with time hopefully. When we were in the capstone block, we did a couple of shakedowns, we did a brief resistor in parallel test that worked great, Fady set up the sensors, and we modified parts we already had to make them work for shakedowns.  The research I did this week was about materials. I researched silicone sheets, silicone molding, glue, and sutures. For each category I found biocompatible and regular options. The regular options are much cheaper and easier to get.  Here are the links to the products I found:  Research Mold and Curing Silicone:  Biocompatible: https://www.elkem.com/silicones/offer/healthcare/medical-grade/liquid-silicone-rubber/ I would suggest soft or mid durometer because it would be less preventative of the tube expanding. Less resistance. Another option is:  https://products-silicones...
Read more

Semester 2 - Week 13 Kierstin

Image
  Lab time:  This week we did our pig head surgery simulation for our verification testing on surgical procedures, and if the device is mobile or not.  Our pig arrived in a box full of packing peanuts. It was very heavy and surprisingly very clean.  We unpackaged the head and placed it in our pre-prepared surgical location. We used trays and covered the table with sticky paper so it would be easy to clean, and nothing would get pig blood on it if it wasn't supposed to.  We started our surgery by suturing the eye so it looked away and giving us a clear spot to cut for the valve insertion. We put the suture through the sclera and then tied it around his ear so it wouldn't move during the surgical procedure.  We then cut the conjunctiva and created a pocket for the valve. I did the main cutting, Brinkley took pictures, and Alex helped give tools and be an extra hand in the surgery. We used scissors to cut it, and then players to create the pocket.  We ins...
Read more